Sidebar
dictionary:xtension:configurebaseaddress
Table of Contents
Configure Base Address to
This verb only applies to the “LynX-Port” X10 interface. If you are lucky enough to have one of these then this verb will set the base address of the analog inputs.
Usage:
configure base address to (text, 1 X10 housecode [A-P])
Examples:
configure base address to "B"
dictionary/xtension/configurebaseaddress.txt · Last modified: 2009/09/28 20:56 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
