Sidebar
dictionary:xtension:signalstrength
This is an old revision of the document!
Table of Contents
Signal Strength
Valid only during the reception of a command in the ON or OFF script of a unit. This value will be set only with supported interfaces, right now the PowerLinc and the UPB interfaces.
Usage:
signal strength
returns an integer.
Examples:
if (signal strength) is less than 10 then write log "The signal strength is very low! end if
dictionary/xtension/signalstrength.1254171592.txt.gz · Last modified: 2009/09/28 20:59 by 127.0.0.1
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
