supported_hardware:wiz
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
supported_hardware:wiz [2021/02/14 15:30] James Sentman [Setting Scenes From a Script:] |
supported_hardware:wiz [2021/02/14 15:37] James Sentman [Known Issues and Yet To Do:] |
||
|---|---|---|---|
| Line 80: | Line 80: | ||
| ====Known Issues and Yet To Do:==== | ====Known Issues and Yet To Do:==== | ||
| - | * Scenes are still a work in progress. | + | * Values often pop down one from what you set them after the next poll. For example you set the light to 100 and it resets to 99 after the next poll. This is a problem with conversion between the internal 0-255 value and XTensions 0-100 percent that is not completely sorted everywhere. This will be fixed before the release. |
| + | |||
| + | * If you are running a scene and issue a regular turnon or turn off it will reset the bulb to a non-scene regular setting but the value in XTension will not remove the name of the last scene until the next poll. This will be fixed before the non-beta release. | ||
| + | |||
| + | * Setting the scene to “None” does not stop the scene yet. Use a turn off or turn on to a specific color or color temperature to cancel a scene for the moment. | ||
| * If the bulb goes offline you’ll get errors in the log about it not being available for polling rather than an error in the Unit display as is the norm. This will be fleshed out in the next version. | * If the bulb goes offline you’ll get errors in the log about it not being available for polling rather than an error in the Unit display as is the norm. This will be fleshed out in the next version. | ||
supported_hardware/wiz.txt · Last modified: 2021/02/14 17:49 by James Sentman
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
