This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
supported_hardware:wiz [2021/02/14 14:36] James Sentman added setup screenshot and discoverdevices command |
supported_hardware:wiz [2021/02/14 15:30] James Sentman [Setting Scenes From a Script:] |
||
---|---|---|---|
Line 59: | Line 59: | ||
would set the bulb to run the “Party” scene at a speed of 200 and full brightness. | would set the bulb to run the “Party” scene at a speed of 200 and full brightness. | ||
+ | |||
+ | There is some oddness about how the bulbs respond to these commands that I haven’t figured out yet. When trying to just change the speed of the Party scene without changing the brightness the command is often ignored. If however you also change the brightness as well it seems to accept it. There also appear to be limits to what speeds are available at lower dimming ranges. Some experimentation may be necessary to get these bulbs to do what you desire. | ||
---- | ---- |