supported_hardware:veraui7
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
supported_hardware:veraui7 [2018/07/08 14:39] James Sentman [Update Neighbor Nodes] |
supported_hardware:veraui7 [2018/07/08 14:39] James Sentman [Clear KWH] |
||
|---|---|---|---|
| Line 196: | Line 196: | ||
| ===Clear KWH=== | ===Clear KWH=== | ||
| - | This is for KWH Measurement units and is the same as just telling the unit to turn off. That will reset the KWH reading to 0. You should not have to call this directly but you can if you wish. There is also a contextual menu option to clear a KWH devices value back to 0. Note that not all Vera devices that support sending this value support clearing the value. If your value dies not go to 0 after sending this command then the device won’t let you reset it. | + | This is for KWH Measurement units and is the same as just telling the unit to turn off. That will reset the KWH reading to 0. You should not have to call this directly but you can if you wish. There is also a contextual menu option to clear a KWH devices value back to 0. Note that not all Vera devices that support sending this value support clearing the value. If your value does not go to 0 after sending this command then the device won’t let you reset it. |
| ---- | ---- | ||
supported_hardware/veraui7.txt · Last modified: 2019/07/02 14:21 by James Sentman
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
