User Tools

Site Tools


supported_hardware:rtl_433

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
supported_hardware:rtl_433 [2021/05/30 15:22]
James Sentman [History:] added 0.2 info
supported_hardware:rtl_433 [2021/06/23 12:56] (current)
James Sentman added unit naming convention info
Line 100: Line 100:
  
 Run the “rtl_eeprom” program from there and use it to write a new serial number to the radio. Do this for each radio and then enter the same number into the SDR Serial Number field in the setup window for that interface above. Run the “rtl_eeprom” program from there and use it to write a new serial number to the radio. Do this for each radio and then enter the same number into the SDR Serial Number field in the setup window for that interface above.
 +
 +====Unit Naming Convention:​====
 +When a signal is received from a unit that does not yet exist in XTension and the Create New Units checkbox is turned on the unit is created with a descriptive name that will help you to find it and figure out what device it corresponds to. This name is not important after that point and once you have found the unit in XTension you should give it a more descriptive name for your purposes. You do not have to keep the same Unit name that was assigned when the unit was automatically created.
  
  
supported_hardware/rtl_433.txt · Last modified: 2021/06/23 12:56 by James Sentman