This shows you the differences between two versions of the page.
supported_hardware:radiora2 [2019/02/21 17:19] James Sentman created |
supported_hardware:radiora2 [2019/02/21 17:22] James Sentman [Output] |
||
---|---|---|---|
Line 22: | Line 22: | ||
===Output=== | ===Output=== | ||
- | Most devices you will want to control can be setup as a generic “Output” type. In this case the Unit address will correspond to the Integration ID that was assigned in the Hub. If you created the unit by physically controlling the switch then the address will already be filled in. After creating the unit either manually or by physically clicking the switch or other device and having it be created by XTension automatically you should set the dimmable property if the device is a dimmer. | + | Most devices you will want to control can be setup as a generic “Output” type. In this case the Unit address will correspond to the Integration ID that was assigned in the Hub. If you created the unit by physically controlling the switch then the address will already be filled in. Once the unit is created you can set the dimmable property if the device is a dimmer. |
Output devices support the “rate” parameter to the [[dictionary:unitcontrol:turnon|]], [[dictionary:unitcontrol:turnoff|]] and [[dictionary:unitcontrol:dim|]] commands. If included that value will be forwarded on to the Hub along with the command. | Output devices support the “rate” parameter to the [[dictionary:unitcontrol:turnon|]], [[dictionary:unitcontrol:turnoff|]] and [[dictionary:unitcontrol:dim|]] commands. If included that value will be forwarded on to the Hub along with the command. |