supported_hardware:ad2usb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
supported_hardware:ad2usb [2017/11/26 13:27] James Sentman [this is still alpha] |
supported_hardware:ad2usb [2017/11/26 15:00] James Sentman [Alarm Zones] |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| All zones setup in the system can also be configured to XTension units. These are receive only and the units in XTension cannot be used to trigger a zone in the alarm panel. Create a unit in XTension addressed starting with “ZONE” and then the 3 digit zone number. For example, an XTension unit with the address “ZONE003” will correspond to Zone 3 in the alarm panel. | All zones setup in the system can also be configured to XTension units. These are receive only and the units in XTension cannot be used to trigger a zone in the alarm panel. Create a unit in XTension addressed starting with “ZONE” and then the 3 digit zone number. For example, an XTension unit with the address “ZONE003” will correspond to Zone 3 in the alarm panel. | ||
| + | Prior to XTension version 9.4 only zones actually reported as faulted would send commands to XTension. Other zone messages were ignored. This means that if you had created a non-fault zone for some other kind of sensor that zone would not have updated in XTension. In version 9.4 I changed the zone handling so that non-fault zones that send an alarm message will also update their XTension units when they are alarmed. | ||
| ===Individual special units=== | ===Individual special units=== | ||
| * address: “ARMEDAWAY” currently read only, is the panel armed away | * address: “ARMEDAWAY” currently read only, is the panel armed away | ||
supported_hardware/ad2usb.txt · Last modified: 2017/11/26 15:03 by James Sentman
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
