Mac Home Automation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====Initialize Controller====
resends any initial setup information to an interface device. For example for a CM11 the EEPROM memory will be erased. Can be used to clear up any problems that might get stuck in an interface. For other devices listed below the command does not erase any memory or do any factory resets, just sends a reboot command as listed:

Any newer plugin for which a command exists to reboot or restart the device should support this. Some plugins may also implement a “reboot()” type command other other. See the individual plugin pages for more info.


Original Plugins that support this command:
  * [[supported_hardware:vera|Vera]] (sends a reboot command, no settings changed or erased. Added in version 9.4)
  * [[supported_hardware:ad2usb|AD2USB]] (sends a reboot command, no settings changed or erased. Added in version 9.4)
  * [[supported_hardware:radiothermostat|RadioThermostat]] (sends a reboot command, no settings changed or erased. Added in version 9.1)
  * [[supported_hardware:cm11a|CM11a]] (clears device memory of any stored events or commands that might be stuck)
  * [[supported_hardware:cm15a|CM15a]] (clears device memory of any stored events or commands that might be stuck)
  * [[supported_hardware:lynx|Lynx]] (resets device settings)
  * [[supported_hardware:zwave|ZTroller]] (resets any saved eeprom settings in the device)

 
===Usage:===
**initialize controller** (text, name of the interface)

Mac Home Automation

User Tools

Site Tools

Page Tools